Operations of eps pelletizor for new users
This machine is eps recycling machine and Beginner for eps pelletizor need read this article for guide.
1.There is heating ring on each top and bottom screw along with switch for it.you can open and close it with the needed temperature.
2.You can start working when the temperature reach 180’C. How to know when it reaches 180’C? For the machine without temperature display,You can test it with a eps foam to touch the head of feeding barrel,it is ok if the foam can melt.For the machine without temperature display,you can read it on the display.
3.Feed the foam waste with a few amount to test if the extruded noodles are melted, feed more after the noodles are melted.You can stop the heating electricity if the temperature is over heated.
4.One or two pcs of filter mesh with mesh value 20-80 are needed on the bottom head of screw.the mesh value is higher,more impurity can be filtered. Auxiliary filter mesh are needed.you need change it if the output noodles are not smooth,cause it may be blocked.The copper filter mesh can be recycled to work after burned to clear the impurity.
- 0086 13833131292
- 0086 311 86558425